5/11/2023 0 Comments Glock 30274 ejector![]() Disclaimer: When removing the pre-travel, the installer must be knowledgeable regarding the safeties function, and it is their responsibility to keep the safeties working properly.īuy GEN 5/G44 Trigger Housing (NO EJECTOR) w/Pre-Travel and Over-Travel Stops. The setscrew has been milled and polished on the end where the trigger bar hits for a smoother action. The adjustable over-travel stop is preset when shipped and loc-tited even though the setscrew has been installed in a way that it will not move under recoil, but can be fine tuned to your preference with the furnished hex wrench. It comes with trigger spring and hex wrenches for the setscrews installed in the trigger housing that allows you to adjust the pre-travel and over-travel. Glock Gen 3 OEM 9mm Slides (Stripped & Complete) G17, 19, 26 & 34. This part does not have pre-travel removed when shipped. Glock OEM 9mm Trigger Housing SP30275 Ejector 30274 for Gen 4 Glock 17 19 26 34: 39. Some Glock Armorers particularly the GSSF match Armorers already have this ejector, but if you can't find one who has the new ejector you'd have to send it in to Glock so they can replace the ejector. ![]() The ejector can be pulled out of your housing with pliers, and then inserted in my custom housing. Glock has a new ejector for Gen4 to fix that problem, the ejector that's in the gun now should be stamped '336', the new ejector is stamped '30274'. Gen 5 / G44 OEM Trigger Housing (No Ejector) - Use your ejector in my Pre-travel/Over-Travel Stop Trigger Housing. GEN 5 / G44 Trigger Housing (NO EJECTOR) w/Pre-Travel and Over-Travel Stops. SF models use the same Trigger Housing as the Gen 4īuy Gen 1-3 Pre-Over Travel Trigger Housing.īuy Gen 4 Pre-Over Travel Trigger Housing.Generation 1, 2, and 3 use the same Trigger Housing.Disclaimer: When removing the pre-travel, the installer must be knowledgeable regarding the safeties function, and it is their responsibility to keep the safety's working properly. The setscrew has been milled and polished on the end where the trigger bar hits resulting in a smoother action. I researched the problem and found the Glock 30274 ejector (gen 4) has successfully fixed a lot of people's Glock ejection. A hex wrench has also been included for fine tuning the over-travel to your preference. Ammo was weak and the gun was a little dry, but that shouldn't matter. The adjustable over-travel stop is preset when shipped and Loctite has been applied to the setscrew even though it has been installed in a way that it will not move under recoil. Generations 1 - 4 Trigger Housing! This OEM trigger housing comes with a furnished hex wrench for the setscrew installed in the trigger housing which allows you to adjust the pre-travel distance to your preference. ![]() Trigger Housing with Pre-Travel and Over-Travel Stops.
0 Comments
Leave a Reply. |